How To Restore Stock Firmware/ROM In Moto E 2015

Learn How To Restore Motorola Moto E 2015 2nd Generation Back To Stock Firmware / ROM with easy method and step by step instructions. In our last article we wrote about How To Install CM12 Custom ROM In Moto E 2015If the Custom ROM experience is not going well for you and you want to restore your device back to Stock Firmware then you are at right place.

Moto-E-2015-2

Image Source : androidsis.com

Before You Begin:

  • This method is only for Moto E 2015 2nd Generation.
  • Make sure your device is fully charged (Minimum 60%).
  • Download and Install Moto E USB Drivers from here.
  • Install and Setup ADB in your PC. Click Here for proper guide.
  • Enable USB Debugging in your device. Click Here if you don’t know how to enable USB Debugging.

Download Required Files:

  • Download and extract the stock Firmware according to your device model number.
  • If the firmware file you downloaded is a .xml.zip file then download Motorola Fastboot and extract the .exe into the same folder as the stock firmware files (the same folder as the .bin and .img files). If your firmware is a .tar.gz file then skip this step.

How To Restore Stock ROM:

  • Follow all the steps given above for safe flashing.
  • Boot your device into Bootloader Mode, Power Off your device and then Press and hold ‘Volume down’ then power on the phone.
  • Now connect your device to PC with USB Cable.
  • Download MOTOEFLASHALL.bat. Place the .bat file inside the extracted firmware folder and run it.
  • Your device will automatically reboot now.

That’s it!! Your device is restored back to Stock Firmware.

 

 

Leave a Reply

Your email address will not be published.